Bronco 2 foamboard rc airplane - #1 maden Started making the bronco2 free plane that Tim McKay has unveiled this week. He is very nice and has great dexterity. I also want to learn his flight control skills. He introduces a lot of foamboard and balsa wood planes. Here is the free plan. Very simple and looked good for beginners to fly. I want to make it quickly and blow it up ✌✌ The foam board was 5mm thick. The motor is a leopard 2826 1050kv. (The thrust is about 800g, which seems to be sufficient when using an 8x4 prop.) 30A ESC , 3S 1300mah lipo (tim used a 2-cell battery. I don't have a 2-cell, so go with a 3-cell) Tomorrow, I think I'll have to make the fuselage and aileron. :-) Wing span: 30inch (762mm) I read the pdf in AutoCAD and scaled it to the actual measurement (wing length 30 inches = 762mm), and then measured and worked on it. A thin layer of glue on the joint area improves strength. I cut the fuselage and wings on paper with a laser, checked the assembl...